Considering that the overseas control measures for the epidemic are not as timely and demanding as our country, the impact of the fermentation of the overseas epidemic on China ’s direct and indirect exports of steel may be less than that of China ’s previous decline in demand, but the process of decline is in time It may be more extended. If we estimate according to the impact time of 2-3 quarters, about 20% of the production decline, then the continuous fermentation of the overseas epidemic will affect the comprehensive export of China ’s steel (including direct and indirect exports) for the whole year is about 10% to 15 %. Combined with our previously calculated total steel export accounted for about 13.9% of the total domestic steel production, it is converted to an adverse impact of about 1.3-2.1% on China's total steel demand.

Epoxy topcoat belongs to the two-component epoxy resin topcoat variety, which has the special properties of wear resistance, impact resistance, excellent water resistance, salt spray resistance and heat resistance (continuous 150 ° C). It is suitable for indoor basements without sunlight Anticorrosive and decorative topcoat in the environment.

Effect of Curing Agent RatioWith the rapid economic growth, the production and consumption of steel have increased rapidly, and the entire steel industry has al

1.The Reason of Wrinkling
Stamping is a forming method that uses presses and dies to apply external force to plates, strips, pipes, and profiles to make them p

Wear Resistant Steel NM400
NM400 is a high-strength wear-resistant steel plate. NM400 has quite high mechanical strength; its mechanical properties are 3 to 5 t

Cold rolled sheet is further rolled from hot rolled steel. It is widely used in auto parts and electrical appliance manufacturer. Due to rolling without extra heating, the cold rolled steel is clean on surface, bright and high accuracy.
The thickness accuracy of cold rolled products is determined by the cold rolling process. Rolling force and strip tension are computer-controlled to minimize thickness deviations during rolling, based on measurements of the strip thickness at the entry and delivery sides of the mill.